No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configurations

Checking the Configurations

After configuring RSVP authentication, you can view information about RSVP authentication.

Prerequisites

RSVP authentication has been configured.

Procedure

  • Run the display mpls rsvp-te command to check RSVP-TE configurations on a specific interface.
  • Run the display mpls rsvp-te peer [ interface interface-type interface-number | peer-address ] command to check RSVP-TE neighbor information on an RSVP-TE-enabled interface.

Example

Run the following command to check the previous configurations.

Run the display mpls rsvp-te peer command to view information about RSVP-TE neighbors on an RSVP-TE-enabled interface.

<HUAWEI> display mpls rsvp-te peer
Interface GigabitEthernet1/0/1
 Neighbor Addr: 10.1.1.2
 SrcInstance: 0x4F7FEC90                NbrSrcInstance: 0x0
 PSB Count: 0                           RSB Count: 1
 Hello Type Sent: NONE                  Neighbor Hello Extension: DISABLE
 SRefresh Enable: NO
 Authentication: ENABLE
 WindowsSize: 1
 Last Valid Seq # rcvd: NULL

Remote Node id Neighbor
 Neighbor Addr: 2.2.2.9
 SrcInstance: 0x4F7FEC90                NbrSrcInstance: 0x0
 PSB Count: 0                           RSB Count: 0
 Hello Type Sent: NONE                  Neighbor Hello Extension: DISABLE
 SRefresh Enable: NO
 Authentication: ENABLE
 WindowsSize: 1
 Last Valid Seq # rcvd: NULL

Config Neighbor
 Neighbor Addr: 2.2.2.9
 SrcInstance: 0x4F7FEC90                NbrSrcInstance: 0x0
 PSB Count: 0                           RSB Count: 0
 Hello Type Sent: NONE                  Neighbor Hello Extension: DISABLE
 SRefresh Enable: NO
 Authentication: ENABLE
 WindowsSize: 1
 Last Valid Seq # rcvd: NULL
Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102386

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next