No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Priority Values for an MPLS TE Tunnel

Setting Priority Values for an MPLS TE Tunnel

The priority values are set on the ingress of an MPLS TE tunnel. Preemption is performed based on the setup and holding priorities during the establishment of an MPLS TE tunnel.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface tunnel tunnel-number

    The view of the MPLS TE tunnel interface is displayed.

  3. Run:

    mpls te priority setup-priority [ hold-priority ]

    The priority values are set for the MPLS TE tunnel.

    Both the setup and holding priority values range from 0 to 7. The smaller the value, the higher the priority.

    NOTE:

    The setup priority value must be greater than or equal to the holding priority value. This means the setup priority is lower than or equal to the holding priority.

  4. Run:

    commit

    The configuration is committed.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102482

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next