No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Hop Limit for a CR-LSP

Setting the Hop Limit for a CR-LSP

The hop limit set on an ingress is the maximum number of hops on a path along which a CR-LSP is to be established. The hop limit is a constraint used during path selection.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface tunnel tunnel-number

    The view of the MPLS TE tunnel interface is displayed.

  3. Run:

    mpls te hop-limit hop-limit-value [ best-effort | secondary ]

    The hop limit of a CR-LSP is set.

  4. Run:

    commit

    The configuration is committed.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101476

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next