No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the IGP Shortcut

Configuring the IGP Shortcut

An IGP shortcut is configured on the ingress of a CR-LSP. The IGP shortcut prevents a route of a CR-LSP from being advertised to neighbors or used by the neighbors.

Context

NOTE:

IGP shortcut and forwarding adjacency cannot be configured simultaneously.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface tunnel tunnel-number

    The view of the MPLS TE tunnel interface is displayed.

  3. Run:

    mpls te igp shortcut [ isis | ospf ] or mpls te igp shortcut isis hold-time interval

    The IGP shortcut is configured.

    hold-time interval specifies the period after which IS-IS responds to the Down status of the TE tunnel.

    If a TE tunnel goes Down and this parameter is not specified, IS-IS recalculates routes. If this parameter is specified, IS-IS responds to the Down status of the TE tunnel after only the specified interval elapses. It either recalculates routes or not depending on the TE tunnel status:
    • If the TE tunnel goes Up, IS-IS does not recalculate routes.
    • If the TE tunnel goes Down, IS-IS still recalculates routes.

  4. Run:

    mpls te igp metric { absolute | relative } value

    The IGP metric of the TE tunnel is configured.

    Either of the following parameters is set when configuring the metric value used by a TE tunnel during IGP shortcut path calculation:

    • If absolute is configured, the TE tunnel metric value is equal to the configured metric value.

    • If relative is configured, the TE tunnel metric value is equal to the sum of the IGP route metric value and relative TE tunnel metric value.

  5. For IS-IS, run:

    isis enable [ process-id ]

    IS-IS is enabled on the tunnel interface.

  6. For OSPF, run the following commands in sequence.

    • Run:

      quit

      The system view is displayed.

    • Run:

      ospf [ process-id ]

      The OSPF view is displayed.

    • Run:

      enable traffic-adjustment

      Traffic adjustment is enabled.

  7. Run:

    commit

    The configuration is committed.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102048

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next