No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Locking the Tunnel Configuration

Locking the Tunnel Configuration

Tunnel configurations can be locked by the controller when the configurations are sent to a NE40E.

Usage Scenario

In service delivery, a controller delivers tunnel configurations to a NE40E. The NE40E uses the obtained configurations to create a tunnel or modify an existing tunnel. To prevent users from modifying such tunnel configurations, the controller delivers the mpls te lock command to lock the configurations, in addition to configurations to the NE40E. Before you modify the configuration of a tunnel, run the undo mpls te lock command to unlock the tunnel configuration on the tunnel interface.

Pre-configuration Tasks

Before locking the tunnel configuration, complete the following tasks:

  • Configure the controller to deliver tunnel configurations to a NE40E.

  • Assign a user management rights.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface tunnel interface-number

    The tunnel interface view of an MPLS TE tunnel is displayed.

  3. Run:

    mpls te lock

    The configuration of the MPLS TE tunnel is locked.

  4. Run:

    commit

    The configuration is committed.

Checking the Configurations

After locking the tunnel configurations, verify that no command can be run on the tunnel interface to modify configurations and commands can be run only after the undo mpls te lock command is run to unlock the configurations.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102509

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next