No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a DS-TE Mode

Configuring a DS-TE Mode

You can configure an MPLS TE tunnel to work a DS-TE mode, either IETF mode or non-IETF mode.

Context

Perform the following steps on each LSR in a DS-TE domain:

NOTE:
If bandwidth constraints are configured for a tunnel, the IETF and non-IETF modes cannot be switched to each other.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    mpls

    The MPLS view is displayed.

  3. Run:

    mpls te ds-te mode { ietf | non-ietf }

    A DS-TE mode is specified.

  4. Run:

    commit

    The configuration is committed.

Follow-up Procedure

The IETF mode and non-IETF mode can be switched between each other on the NE40E. Table 3-10 describes switching between DS-TE modes. The arrow symbol (—>) indicates "switched to."

Table 3-10  Switching between DS-TE modes

Item

Non-IETF—>IETF

IETF—>Non-IETF

Changes in bandwidth constraint models

N/A

RDM—>N/A

MAM—>N/A

Bandwidth change

BC0 bandwidth values remain.

BC0 bandwidth values remain.

TE-class mapping table

If the TE-class mapping table is not configured, the default TE-Class mapping table is used. Otherwise, the configured one is used.
NOTE:
For information about the default TE-class mapping table, see Table 3-11.

No TE-class mapping table is used.

  • A TE-class mapping table is not deleted once it is configured.
  • If no TE-Class mapping table is configured, the default TE-Class mapping table is deleted.
Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101319

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next