Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Traffic Switching Policy for a Hot-Standby CR-LSP
This section describes how to configure a traffic switching policy for a hot-standby CR-LSP. The traffic switching policy determines whether to switch traffic back to the primary CR-LSP and sets a switchback delay.
Context
When a primary CR-LSP is Down, traffic switches to the hot-standby CR-LSP. When the primary CR-LSP is Up, traffic switches back by default. This configuration provides the flexibility to control the traffic switchover behavior.
Procedure
- Run:
system-viewThe system view is displayed.
- Run:
interface tunnel tunnel-number
The view of the MPLS TE tunnel interface is displayed.
- Run:
mpls te backup hot-standby mode { revertive [ wtr interval ] | non-revertive }
The traffic switching policy is configured for the hot-standby CR-LSP and the switchback delay is set.
- Run:
commitThe configurations are committed.
Previous
