No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configurations

Checking the Configurations

After configuring a tunnel protection group, run display commands to view information about the tunnel protection group and the binding between the working and protection tunnels.

Prerequisites

A tunnel protection group has been configured.

Procedure

  1. Run the display mpls te protection tunnel { all | tunnel-id | interface tunnel-interface-name } [ verbose ] command to check information about a tunnel protection group.
  2. Run the display mpls te protection binding protect-tunnel { tunnel-id | interface tunnel-interface-name } command to check the binding between the working and protection tunnels.

Example

After completing the configurations, you can run a display command to view the configuration of a tunnel protection group.

# Run the display mpls te protection tunnel all command on the ingress to view information about the tunnel protection group.

<HUAWEI> display mpls te protection tunnel all
------------------------------------------------------------------------
No. Work-tunnel status  /id  Protect-tunnel status /id    Switch-Result
------------------------------------------------------------------------
1          non-defect   /100        non-defect     /101     work-tunnel

# Run the display mpls te protection binding protect-tunnel tunnel-id command. The command output shows that a protection tunnel has been bound to a working tunnel.

<HUAWEI> display mpls te protection binding protect-tunnel 101
------------------------------------------------------------------------
Binding information of( tunnel id:  101 )
------------------------------------------------------------------------
    Protect-tunnel id                    :101
    Protect-tunnel name                  :Tunnel1
    Maximum number of bound work-tunnels :8
    Currently bound work-tunnels         :Total( 1 )
                                         :Tunnel2
Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101592

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next