No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Entropy Label for Tunnels

Configuring the Entropy Label for Tunnels

The entropy label can be used to improve load balancing in traffic forwarding.

Usage Scenario

With the increasing growth of user networks and the extending scope of network services, load-balancing techniques are used to improve bandwidth between nodes. A great amount of traffic results in load imbalance on transit nodes. To address the problems, the entropy label capability can be configured to improve load balancing performance.

Pre-configuration Tasks

Before configuring the entropy label for tunnels, Enabling MPLS TE and RSVP-TE.

Configuration Procedures

Figure 3-16  Configure the entropy tag flow chart for the tunnel
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101561

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next