No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Dynamic BFD for CR-LSP

Configuring Dynamic BFD for CR-LSP

Static BFD for CR-LSP can be configured to monitor an RSVP CR-LSP and protect traffic along a CR-LSP.

Usage Scenario

Compared with static BFD, dynamically creating BFD sessions simplifies configurations and reduces configuration errors.

Currently, dynamic BFD for CR-LSP cannot detect faults in the entire TE tunnel.

NOTE:

BFD for LSP can function properly though the forward path is an LSP and the reverse path is an IP link. The forward and reverse paths must be established over the same link. If a fault occurs, BFD cannot identify the faulty path. Before deploying BFD, ensure that the forward and reverse paths are over the same link so that BFD can correctly identify the faulty path.

Pre-configuration Tasks

Before configuring dynamic BFD for CR-LSP, configure an RSVP-TE tunnel.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102230

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next