No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static BFD for TE

Configuring Static BFD for TE

This section describes how to configure static BFD for TE to detect faults in a TE tunnel.

Usage Scenario

If a BFD session detects a fault in a TE tunnel, the BFD module instructs VPN FRR to quickly switch traffic, which reduces the adverse impact on services.

Pre-configuration Tasks

Before configuring the static BFD for TE, configure a static CR-LSP or an MPLS TE tunnel.

Configuration Procedures

Figure 3-18  Static BFD for TE configuration

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101899

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next