No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Local LDP Session

Configuring a Local LDP Session

An MPLS LDP session can be configured only after LSR IDs are configured and MPLS LDP is enabled on both ends of the MPLS LDP session.

Usage Scenario

An LDP session is established over a TCP connection. After the TCP connection is set up, LSRs negotiate parameters of the LDP session. If the negotiation is successful, an LDP session can be established.

After the local LDP session is established, LSRs assign labels to establish an LDP LSP.

When LDP LSPs carry Layer 2 Virtual Private Network (L2VPN) and Layer 3 Virtual Private Network (L3VPN) services, you can specify an LSR ID for each local LDP session on the current LSR to isolate VPN services.

Pre-configuration Tasks

Before configuring a local LDP session, configure static routes or an IGP to ensure that IP routes between LSRs are reachable.

Configuration Procedures

Figure 4-2  Local LDP session configuration
Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101087

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next