No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring an LDP Transport Address

(Optional) Configuring an LDP Transport Address

Before establishing an LDP session, two LSRs confirm each other's LDP transport address and set up a TCP connection.

Context

An LDP transport address is used to set up a TCP connection between peers. A route to the LDP transport address must be reachable on each peer. An LSR ID, which is the loopback interface address, serves as the LDP transport address.
NOTE:
  • The LDP sessions over multiple links between two LSRs can be established using the same pair of transport addresses.

  • A change in an LDP transport address will terminate the associated LDP session. Exercise caution when configuring an LDP transport address.

The default LDP transport address is recommended.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The view of the interface on which an LDP session is to be established is displayed.

  3. Run:

    mpls ldp transport-address { interface-type interface-number | interface }

    The IP address of a specified interface is configured as an LDP transport address.

    • interface-type interface-number: LDP uses the IP address of this specified interface as the transport address.

    • interface: LDP uses the IP address of an existing interface as the transport address.

  4. Run:

    commit

    The configurations are committed.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 103056

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next