No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the PHP Feature

(Optional) Configuring the PHP Feature

The penultimate hop popping (PHP) function can be enabled after you configure a specific label on the egress before the egress assigns the label to the penultimate hop.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    mpls

    The MPLS view is displayed.

  3. Run:

    label advertise { explicit-null | implicit-null | non-null }

    A label assigned to the penultimate node is specified.

    You can specify one of the following parameters:

    • explicit-null: disables PHP. If this parameter is configured, the egress assigns an explicit null label with value 0 to the penultimate node. explicit-null supports MPLS QoS, which helps save label resources in the egress. If E2E services with QoS attributes carried in the EXP field in a label are transmitted, explicit-null can be configured to save label resources and prevent EXP value loss.

    • non-null: disables PHP. If this parameter is configured, the egress assigns a label with a value greater than or equal to 16 to the penultimate node. The non-null label consumes resources on the egress, which is not recommended. This parameter can be used when the egress needs to identify services based on labels.

    NOTE:

    After the label advertise { explicit-null | implicit-null | non-null } command is run to change the label distribution mode on the egress, the modification takes effect on new LSPs but not on existing LSPs. To enable the modification to take effect on the existing LSPs, run the reset mpls ldp or lsp trigger command.

  4. Run:

    commit

    The configurations are committed.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 103033

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next