No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configurations

Checking the Configurations

After configuring LDP extension for inter-area LSPs, you can view information about the establishment of inter-Area LSPs.


The LDP extension for inter-area LSP has been configured.


  • Run the display mpls lsp command to check the setup of inter-area LSPs after LDP is configured to search for routes based on the longest match rule to establish LSPs.


Configure LDP to search for routes based on the longest match rule to establish LSPs. and are routes to another IGP area. Run the display mpls lsp command. The command output shows that an inter-area LSP has been established.

[HUAWEI] display mpls lsp
                 LSP Information: LDP LSP
FEC                In/Out Label  In/Out IF                      Vrf Name         NULL/3        -/GE1/0/0         1024/3        -/GE1/0/0         NULL/1025     -/GE1/0/0         1025/1025     -/GE1/0/0         NULL/1026     -/GE1/0/0         1026/1026     -/GE1/0/0
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101285

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next