No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static BFD to Monitor an LDP LSP

Configuring Static BFD to Monitor an LDP LSP

Static bidirectional forwarding detection (BFD) can be configured to detect faults in an LDP LSP.

Usage Scenario

BFD implements fast detection at the millisecond level. To enable a device to rapidly monitor whether LDP LSPs are faulty, establish BFD sessions.

When configuring static BFD to monitor an LDP LSP, note the following:

  • You can bind a BFD session to an LDP LSP only on the ingress.

  • An LDP LSP to be monitored by static BFD can be established only using host routes.

Pre-configuration Tasks

Before configuring static BFD to monitor an LDP LSP, complete the following tasks:

  • Configure network layer parameters to implement network layer connectivity.

  • Enable MPLS LDP on each node and set up an LDP session.

  • Configure an LDP LSP.

Configuration Procedures

Figure 4-5  Static BFD for LSP configuration

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102868

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next