No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Policy for Triggering Dynamic BFD for LDP LSPs

Configuring a Policy for Triggering Dynamic BFD for LDP LSPs

A BFD session can be created to monitor an LDP LSP only after a policy for triggering dynamic BFD is configured.

Context

A policy can be enforced to establish a session of dynamic BFD for LDP LSP in either of the following modes:

  • Host mode: applies when all host addresses are used to establish a BFD session. You can specify nexthop and outgoing-interface to define LSPs that support a BFD session.

  • FEC list mode: applies when only some host addresses are used to establish a BFD session. You can use the fec-list command to specify host addresses.

Perform the following steps on the ingress of an LSP to be monitored:

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. (Optional) To use a FEC list, perform the following operations:
    1. Run:

      fec-list list-name

      A FEC list is created, and the FEC list view is displayed.

    2. Run:

      fec-node ip-address [ nexthop ip-address | outgoing-interface interface-type interface-number ] *

      A FEC node is added to the FEC list.

    3. Run:

      quit

      Return to the system view.

  3. Run:

    mpls

    The MPLS view is displayed.

  4. Run:

    mpls bfd-trigger { host [ nexthop next-hop-address | outgoing-interface interface-type interface-number ] * | fec-list list-name } [ option-tlv ]

    The policy for establishing a session of dynamic BFD for LDP LSP is configured.

    After the command is run, the BFD session starts to be created.

  5. (Optional) Run:

    mpls bfd-option-tlv ip-prefix ip-prefix-name

    An IP prefix list is configured to trigger the establishment of LDP BFD sessions working in compatible mode so that a Huawei device communicates with a specified range of non-Huawei devices.

    If the mpls bfd-trigger command has been run to configure the BFD compatible mode globally, the mpls bfd-option-tlv ip-prefix command does not take effect after being run.

  6. Run:

    commit

    The configuration is committed.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101128

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next