No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling Dynamic BFD to Monitor an mLDP P2MP Tunnel

Enabling Dynamic BFD to Monitor an mLDP P2MP Tunnel

Dynamic BFD for mLDP P2MP tunnel can detect the primary tree faults of a P2MP tunnel only after this function is enabled.


Perform the following steps on each root and leaf node:


  1. Run:


    The system view is displayed.

  2. Run:


    The BFD view is displayed.

  3. Run:


    The system view is displayed.

  4. Run:


    The MPLS view is displayed.

  5. Run:

    mpls mldp bfd enable

    Dynamic BFD is enabled to monitor an mLDP P2MP tunnel.

  6. Run:

    mpls mldp p2mp bfd-trigger-tunnel all

    A policy is configured to dynamically establish a BFD session to monitor an mLDP P2MP tunnel.

  7. Run:


    The configuration is committed.

Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102253

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next