Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configurations
After configuring LDP Auto FRR, you can view information about the LDP Auto FRR LSP.
Procedure
- Run the display mpls lsp command to check information about LSPs after LDP Auto FRR is enabled.
Example
After configuring LDP Auto FRR, run the display mpls lsp command to view information about a backup LSP with destination address 2.2.2.9/32.
<HUAWEI> display mpls lsp Flag after Out IF: (I) - RLFA Iterated LSP, (I*) - Normal and RLFA Iterated LSP ------------------------------------------------------------------------------- LSP Information: LDP LSP ------------------------------------------------------------------------------- FEC In/Out Label In/Out IF Vrf Name 1.1.1.1/32 3/NULL -/- 2.2.2.2/32 NULL/3 -/GE1/0/1 2.2.2.2/32 32837/3 -/GE1/0/1 3.3.3.1/32 NULL/32842 -/GE1/0/2(I*) 3.3.3.1/32 32840/32842 -/GE1/0/2 **LDP FRR** NULL/32829 -/GE1/0/1(I*) **LDP FRR** 32840/32829 -/GE1/0/1 4.4.4.10/32 NULL/3 -/GE1/0/2 4.4.4.10/32 32839/3 -/GE1/0/2 **LDP FRR** NULL/32838 -/LDP LSP **LDP FRR** 32839/32838 -/LDP LSP
Previous
