No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling the Entropy Label Capability on the Egress of an LSP

Enabling the Entropy Label Capability on the Egress of an LSP

The entropy label capability can be configured on the egress of an LSP to load-balance traffic.


The growth of user networks worsens the load imbalance on transit nodes. To address this problem, the entropy label capability can be configured. When the entropy label capability is configured, it must be enabled also on the egress.


  1. Run:


    The system view is displayed.

  2. Run:


    The MPLS view is displayed.

  3. Run:

    entropy-label-capability enable

    The entropy label capability is configured on the egress of an LSP

  4. Run:


    The configuration is committed.

Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101708

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next