No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Automatic mLDP P2MP Tunnel

Configuring an Automatic mLDP P2MP Tunnel

Automatic mLDP P2MP tunnels can only transmit NG MVPN and multicast VPLS traffic.

Context

There is no need to manually specify leaf nodes before automatic mLDP P2MP tunnels are triggered.

NOTE:

After the configuration is complete, preparation for an automatic mLDP tunnel is ready. Automatic mLDP P2MP tunnels can be established automatically when NG MVPN or multicast VPLS is being deployed.

Procedure

  • Enable mLDP P2MP globally
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      mpls ldp

      The MPLS-LDP view is displayed.

    3. Run:

      mldp p2mp

      mLDP P2MP is enabled globally.

    4. (Optional) Run:

      mldp make-before-break

      The mLDP make-before-break (MBB) capability is enabled.

      If the optimal route between a non-root node and a root node on an mLDP P2MP network changes, the non-root node re-selects an upstream node and by default tears down the P2MP LSP.As a result, traffic is dropped before a new P2MP LSP is established. To prevent traffic loss, the make-before-break capability can be enabled on the mLDP network. If the optimal route to the root node changes, the non-root node establishes a new P2MP LSP before tearing down the original P2MP LSP, which minimizes traffic loss.

    5. Run:

      commit

      The configuration is committed.

  • (Optional) Disable mLDP P2MP on an interface

    To flexibly control the path of a P2MP LSP, you can disable mLDP P2MP on a specified interface.

    Disabling mLDP P2MP on an interface helps you plan a network. For example, if links balance traffic on a network, to enable P2MP traffic to travel along a specific link, disable mLDP P2MP on interfaces connected to other links.

    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      interface interface-type interface-number

      The interface view is displayed.

    3. Run:

      mpls mldp p2mp disable

      mLDP P2MP is disabled on the interface.

      Disabling mLDP P2MP on an interface causes P2MP LSPs to fail to be established, while does not affect existing P2P LDP sessions.

    4. Run:

      commit

      The configuration is committed.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102462

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next