No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configurations

Checking the Configurations

After configuring LDP statistics collection, check traffic statistics on the ingress and transit nodes.

Prerequisites

LDP statistics collection has been configured.

Procedure

  • Run the display mpls ldp lsp traffic-statistics [ ipv4-address mask-length ] [ verbose ] command to check LDP traffic statistics.
  • Run the reset mpls traffic-statistics ldp [ ipv4-address mask-length ] command to delete LDP traffic statistics.

Example

If the configurations succeed, you can run the preceding commands to obtain the following results:

Run the display mpls ldp lsp traffic-statistics command to view LDP traffic statistics.

<HUAWEI> display mpls ldp lsp traffic-statistics verbose
 ----------------------------------------------------------------------------------
LDP LSP Traffic Statistics Information
----------------------------------------------------------------------------------
FEC      : 233.112.233.233/32  Current Time  : 2015-07-21 09:10:21
LSR Type : Ingress             Nexthop       : 123.123.123.123
Out Label: 2025                Out Interface : Eth3/0/0
Last 300 seconds output rate 24000 bits/sec, 1050 packets/sec
Realtime 30 seconds output rate 2400 bits/sec, 105 packets/sec
Output: 3000 bytes, 1050 packets

Run the reset mpls traffic-statistics ldp command to delete LDP traffic statistics.

<HUAWEI> reset mpls traffic-statistics ldp
Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101238

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next