No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking LSP Connectivity and Reachability

Checking LSP Connectivity and Reachability

A ping or tracert command enables a device to monitor LSP connectivity and reachability.


Run one of the following commands to perform MPLS ping or MPLS tracert detection.


  • Run the ping lsp [ -a source-ip | -c count | -exp exp-value | -h ttl-value | -m interval | -r reply-mode | -s packet-size | -t time-out | -v ] * ip destination-iphost mask-length [ ip-address ] command in any view to execute an MPLS ping.
  • Run the tracert lsp [ -a source-ip | -exp exp-value | -h ttl-value | -r reply-mode | -t time-out | -s size ] * ip destination-iphost mask-length [ ip-address ] [ detail ] command in any view to execute an MPLS tracert.
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102532

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next