No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configurations

Checking the Configurations

After configuring a dynamic BFD session to monitor a BGP tunnel, you can view BGP BFD session information on the ingress of the BGP tunnel.


The dynamic BFD for BGP tunnel function has been configured.


  • Run the display mpls bfd session protocol bgp [ fec fec-address [ verbose ] ] command to check information about a BFD session with the protocol type of BGP on the ingress on an E2E BGP tunnel.


# Run the display mpls bfd session protocol bgp command on the ingress of an E2E BGP tunnel. The command output shows information about a BFD session that monitors the BGP tunnel.

<HUAWEI> display mpls bfd session protocol bgp
                         BFD Information: BGP  Tunnel
FEC             DISC  OUT-IF           NEXTHOP         TUNNEL         STATE         8192  -               -              Up
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102832

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next