No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking Network Connectivity and Reachability

Checking Network Connectivity and Reachability

Run the ping and tracert commands to check the connectivity and reachability of seamless MPLS networks.


Run the following commands in any view of a BGP LSP endpoint node to check the connectivity and reachability of a BGP LSP.


  • Run the ping lsp [ -a source-ip | -c count | -exp exp-value | -h ttl-value | -m interval | -r reply-mode | -s packet-size | -t time-out | -v ] * bgp destination-iphost mask-length [ ip-address ] command to check BGP LSP connectivity.
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102331

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next