No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configurations

Checking the Configurations

After configuring a GMPLS UNI tunnel, you can view information about the GMPLS UNI tunnel and the tunnel status.

Prerequisites

A GMPLS UNI tunnel has been configured.

Procedure

  • Run the display lmp peer command to check information about LMP neighbors.
  • Run the display explicit-path [ path-name ] [ verbose ] command to check information about the configured explicit path.
  • Run the display mpls te gmpls tunnel path [ path-name ] [ verbose ] command to check GMPLS UNI tunnel path information.
  • Run the display mpls te gmpls tunnel c-hop [ tunnel-name tunnel-name ] [ lsp-id ingress-lsr-id egress-lsr-id tunnel-id lsp-id ] command to check information about the calculated path for a GMPLS UNI tunnel.
  • Run the display mpls gmpls lsp [ in-label in-label | incoming-interface interface-type interface-number | lsr-role { egress | ingress } | out-label out-label | outgoing-interface interface-type interface-number ] * [ verbose ] command to check GMPLS UNI LSP information.
  • Run the display mpls te gmpls tunnel [ name gmpls-tunnel-name ] [ verbose ] command to check information about a GMPLS UNI tunnel.
  • Run the display mpls te gmpls tunnel-interface [ name gmpls-tunnel-name ] command to check information about GMPLS UNI tunnel interfaces on the ingress EN and egress EN.

Example

Run the following command to view the previous configurations.

Run the display mpls te gmpls tunnel-interface command. The command output shows that the tunnel is Up.

<HUAWEI> display mpls te gmpls tunnel-interface
    Tunnel Name       : toD
    Tunnel State Desc : CR-LSP is Up
    Session ID          : 1                     FTid         : 33
    Ingress LSR ID      : 1.1.1.1               Egress LSR ID: 2.2.2.2
    Admin State         : UP                    Oper State   : UP
    Signaling Protocol  : RSVP
    Bandwidth(Kbit/sec) : 1000
    Match Session ID    : -
    Passive             : NO
    Link Protect Type   : REROUTE               LSP Encoding Type : ETHERNET
    Switch Type         : DCSC                  Graceful Deleting : NO
    Bind Interface      : Gmpls-Uni1
    Authentication      : Disabled

    Primary LSP ID      : 1.1.1.1:10
    LSP State           : UP
    Resv Style          : SE              Bandwidth(Kbit/sec)   : 1000
    Explicit Path Name  : unipath
Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101149

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next