No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Disabling a GMPLS UNI Tunnel

Disabling a GMPLS UNI Tunnel

Before you release bandwidth resources of an existing GMPLS UNI tunnel or modify tunnel parameters, disable the GMPLS UNI tunnel on the ingress EN.


To shut down an existing GMPLS UNI tunnel, run the shutdown command on the ingress EN to release label and bandwidth resources assigned to the tunnel. GMPLS UNI tunnel configurations, however, are kept.

To start this tunnel again, run the undo shutdown command to re-establish the tunnel based on the original configuration file. The path of the re-established UNI LSP within a transport network may be different from the original one because topology or bandwidth within a transport network may change.


  1. Run:

    gmpls-tunnel gmpls-tunnel-name

    The view of the established GMPLS UNI tunnel is displayed.

  2. Run:


    A GMPLS UNI tunnel is disabled.

  3. Run:


    The configuration is committed.

Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 103055

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next