No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Resetting a GMPLS UNI Tunnel

Resetting a GMPLS UNI Tunnel

Resetting a GMPLS UNI tunnel can make tunnel configurations to take effect immediately.


If the path within a transport network is re-planned, and configurations on the ingress EN do not change, you can run the following command to reset a GMPLS UNI tunnel. UNI LSPs are re-established according to the new path.


  1. Run the reset mpls te gmpls tunnel gmpls-tunnel-name command to reset a GMPLS UNI tunnel.
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102883

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next