No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - System Monitor 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Session-Reflector

Configuring the Session-Reflector

This section describes how to configure the session-reflector. The session-reflector replies to the probes sent by the session-sender after being notified by the server.

Context

After the session-reflector is configured, the session-reflector can reply to the session-sender with timestamps and serial numbers to help collect statistics about the delay, jitter, and packet loss rate.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    nqa twamp

    The TWAMP view is displayed.

  3. Run:

    reflector

    The session-reflector function is enabled, and the session-reflector view is displayed.

  4. (Optional) Run:

    test-session inactive inactive-interval

    An inactive interval is configured for a test session.

Download
Updated: 2018-07-12

Document ID: EDOC1100028538

Views: 28138

Downloads: 213

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next