No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - Virtual Access 01

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining IP RAN Virtual Cluster Accesss

Maintaining IP RAN Virtual Cluster Accesss

This section describes how to maintain IP radio access network (RAN) virtual cluster access.

Checking VP and VC Continuity

This section describes how to check virtual path (VP) and virtual circuit (VC) continuity.

Prerequisites

Virtual cluster access has been configured.

Context

After you configure virtual cluster access, run the vping command to check VP and VC continuity. If a fault occurs, run the vtracert command to locate the fault.

Procedure

  • Run the vping [ -c count | -exp exp-value | -m interval | -t time-out ] * ap { ap-name | ip-address } [ primary | hotstandby ] command in any view to check the continuity of the primary and backup VPs from a master to an AP.
  • Run the vtracert [ -exp exp-value | -t time-out ] * ap { ap-name | ip-address } [ primary | hotstandby ] command in any view to locate faults on the primary and backup VPs from a master to an AP.
  • Run the vping [ -c count | -exp exp-value | -m interval | -t time-out ] * ap { ap-name | ip-address } interface interface-type interface-number command in any view to check the continuity of the VC from a master to an AP.

Restarting Virtual Cluster Accesss

This section describes how to restart virtual cluster access.

Prerequisites

Virtual cluster access has been configured.

Context

To ensure that changes in virtual cluster access configurations immediately take effect or to manually restore virtual cluster access, run the reset virtual-cluster-access command to restart virtual cluster access.

After you run the command, the original Master Slave Control Protocol (MSCP) channels, virtual paths (VPs), and virtual circuits (VCs) are deleted and reestablished.

Procedure

  • Run the reset virtual-cluster-access [ peer ip-address ] command to restart virtual cluster access.

Using a Master to Log In to and Manage an AP

This section describes how to use a master to log in to an access point (AP) and manage the AP.

Prerequisites

Virtual cluster access has been configured.

Context

Virtual cluster access enables you to use a master to log in to an AP and manage and view AP configurations.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the virtual-cluster-access command to enter the virtual cluster access view.
  3. Run the ap name name ip ip-address command to configure a name for an AP.

    The ip-address parameter specifies the management IP address of an AP.

  4. Run the commit command to commit the configuration.
  5. Run the quit command to return to the system view.
  6. Run the quit command to return to the user view.
  7. Run the ap { ip ap-ip | name ap-name } command to use a master to log in to a specified AP.
Download
Updated: 2018-07-12

Document ID: EDOC1100028541

Views: 7793

Downloads: 92

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next