No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer G5500 Server G560 V5 Compute Node Maintenance and Service Guide 03

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to the iBMC CLI

Logging In to the iBMC CLI

You can log in to the iBMC CLI to manage and monitor the device.

To log in to the iBMC CLI over the network port, ensure that:

  • The network port on the client is properly connected to the management network port on the server by using a network cable.
  • The IP addresses of the client network port and the management network port are on the same network segment.

Prepare the following data before logging in to the iBMC CLI:

  • The default iBMC IP address is 10.10.1.101.
  • The default iBMC user name is Administrator, and the default password is Admin@9000.

Logging In over SSH

The SSH protocol is used to provide secure remote login and other network services on an insecure network.

NOTE:

The SSH service is enabled by default. If the SSH service is disabled, enable it by choosing Configuration > Services on the iBMC WebUI.

To log in to the CLI over SSH, perform the following operations:

  • In Linux
    1. Connect the network port of the configuration terminal to the management network port of the server.
    2. Run the following command in the terminal tool to log in to the iBMC CLI:

      ssh ipaddress

  • In Windows
    1. Download and install the client communications tool that supports SSH.
    2. Connect the network port of the configuration terminal to the management network port of the server.
    3. Enter the user name, password, and IP address of the management network port on the client communications tool to log in to the iBMC CLI.

Translation
Download
Updated: 2018-12-14

Document ID: EDOC1100031432

Views: 23952

Downloads: 39

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next