No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer G5500 Server G560 V5 Compute Node Maintenance and Service Guide 03

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing a GPU Card

Removing a GPU Card

Procedure

  1. Remove the GP608. For details, see Removing the GP608.
  2. Place the GP608 on the ESD floor.
  3. Remove the cover. For details, see Removing the Cover of the GP608.
  4. Determine the GPU card to be removed. Figure 5-102 shows the locations of GPU cards.

    Figure 5-102 Locations of GPU cards

  5. Remove one end of the power cable from the GPU card to be removed. The other end connecting to the PCIe board does not need to be removed.
  6. Loosen the two screws on the GPU card using a Phillips screwdriver. See (1) in Figure 5-103.

    Figure 5-103 Removing a GPU card

  7. Remove the GPU card from the slot. See (2) in Figure 5-103.
  8. Remove the bracket from the GPU card.
  9. Place the removed GPU card in an ESD bag.
  10. If a new GPU card is to be installed, install the removed GPU card bracket on the new card. For details, see 7.
  11. If a new GPU card is not to be installed immediately, install the removed bracket on the GP608 chassis and install a GPU card filler module. Place the power cable in the GP608 cable guide.

    1. Align the GPU filler module with the slot, and insert the GPU filler module into the slot. See (1) in Figure 5-104.
      Figure 5-104 Installing a GPU filler module

    2. Tighten the screw using a Phillips screwdriver to secure the GPU filler module. See (2) in Figure 5-104.

  12. Install the cover of the GP608. For details, see Installing the Cover of the GP608.
Translation
Download
Updated: 2018-12-14

Document ID: EDOC1100031432

Views: 24289

Downloads: 39

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next