No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


FusionServer G5500 Server G560 V5 Compute Node Maintenance and Service Guide 03

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Removing the Supercapacitor

(Optional) Removing the Supercapacitor

  1. Power off the G560 V5. For details, see Powering Off the Compute Node.
  2. Remove the G560 V5. For details, see Removing the G560 V5.
  3. Place the G560 V5 on the ESD floor.
  4. Remove the cover. For details, see Removing the Cover of the G560 V5.
  5. Determine the location of the supercapacitor. See Figure 5-76.

    Figure 5-76 Location of the supercapacitor

  6. Remove the power cable between the supercapacitor and RAID controller card. See (1) in Figure 5-77.

    Figure 5-77 Removing the cable and supercapacitor tray

  7. Use a Phillips screwdriver to loosen the screws that secure the supercapacitor tray and lift the supercapacitor tray. See (2) and (3) in Figure 5-77.
  8. Press and hold down the plastic latch in the arrow directions, and push the supercapacitor out of the supercapacitor tray. See (1) and (2) in Figure 5-78.

    Figure 5-78 Removing a supercapacitor

  9. Place the supercapacitor in an ESD bag.
Updated: 2018-12-14

Document ID: EDOC1100031432

Views: 39837

Downloads: 55

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next