No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


FusionServer G5500 Server iBMC (V300 or Later) User Guide 04

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Querying and Setting Controlled Power-on Configuration (poweronpermit)

Querying and Setting Controlled Power-on Configuration (poweronpermit)


The poweronpermit command is used to query and set the controlled power-on function.


ipmcget -d poweronpermit

ipmcset -d poweronpermit -v <enable | disable> [ip] [netport]


Parameter Description Value
enable Enables the controlled power-on function. -
disable Disables the controlled power-on function. -
ip Specifies the server IP address. -
netport Specifies the port number. 0 to 65535

Usage Guidelines



# Query configuration of the controlled power-on function.

iBMC:/->ipmcget -d poweronpermit
State         : enabled
ManagerIP     :
ManagerPort   : 26957

# Enable the controlled power-on function.

iBMC:/->ipmcset -d poweronpermit -v enable 26957
Set poweronpermit successfully.
Updated: 2018-10-31

Document ID: EDOC1100031438

Views: 93246

Downloads: 49

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next