No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

XH321L V5 Server Node V100R005 Maintenance and Service Guide 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to the Server Node over a Network Port by Using PuTTY

Logging In to the Server Node over a Network Port by Using PuTTY

Procedure

  1. Set an IP address and a subnet mask or add route information for the PC so that the PC can properly communicate with the server.

    You can run the Ping 10.10.1.104 (IP address of the destination server node or HMM) command on the PC command-line interface (CLI) to check the communication between the PC and the server.

  2. Double-click PuTTY.exe.

    The PuTTY Configuration window is displayed, as shown in Figure 10-16.

    Figure 10-16 PuTTY Configuration window

  3. Set the login parameters.

    The parameters should be set as follows:

    • Host Name (or IP address): Enter the IP address of the destination server node or HMM as required, for example, 10.10.1.104.
    • Port: Retain the default value 22.
    • Connection type: Retain the default value SSH.
    • Close window on exit: Retain the default value Only on clean exit.
    NOTE:

    Configure Host Name (or IP address) and Saved Sessions, and click Save. You can double-click the saved record in Saved Sessions to log in to the server next time.

  4. Click Open.

    The PuTTY window is displayed.

    NOTE:

    If you are logging in to the target server for the first time, the PuTTY Security Alert window is displayed. If you trust this site, click Yes. Then the PuTTY window is displayed.

  5. Enter a user name and password to log in.

    NOTE:

    If the user name or password is incorrect during server login, you must connect to PuTTY again.

    After login, the server host name is displayed to the left of the prompt.

Download
Updated: 2019-01-08

Document ID: EDOC1100033003

Views: 7873

Downloads: 12

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next