No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

XH321L V5 Server Node V100R005 Maintenance and Service Guide 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Querying and Setting the IP Address of the Management Network Port

Querying and Setting the IP Address of the Management Network Port

Methods

Determine the IP Address of the management network port using one of the following methods:

  • Check the default IP address.
  • Check the IP address of the management network port using the BIOS.

You can set the IP address on the BIOS.

Querying Default IP Address

The system automatically assigns default IP addresses to the management network ports on server nodes based on the slot numbers. Table 10-1 lists the default IP addresses.

Table 10-1 Default IP addresses

Model

Slot

IP Address

Default Subnet Mask

XH321L V5

Slot 1

10.10.1.101

255.255.255.0

Slot 2

10.10.1.102

Slot 3

10.10.1.103

Slot 4

10.10.1.104

Querying and Setting the IP Address on the BIOS

  1. Connect a USB mouse and keyboard.
  2. Connect a monitor using a VGA cable.
  3. Restart the OS.
  4. Press Delete or F4 on the startup screen.

    NOTE:
    • To go to the Front Page, press F11 or F3.
    • To go to PXE, press F12.
    Figure 10-1 BIOS startup screen

  5. Enter the BIOS password when prompted.

    NOTE:

    The default BIOS password is Admin@9000.

  6. Choose Advanced > IPMI iBMC Configuration, and press Enter.

    The IPMI iBMC Configuration screen is displayed. See Figure 10-2.

    Figure 10-2 IPMI iBMC Configuration

  7. Select iBMC Configuration and press Enter.

    The iBMC Configuration screen displayed shows the IP address of the iBMC network port. See Figure 10-3.

    Figure 10-3 iBMC Configuration

  8. Select IPv4 IP Address and press Enter to go to the configuration screen, and set an IPv4 address for the management network port.
  9. Press F10 to save the settings and exit.
Download
Updated: 2019-01-08

Document ID: EDOC1100033003

Views: 9516

Downloads: 12

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next