No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


XH321L V5 Server Node V100R005 Maintenance and Service Guide 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to the Server Node over a Serial Port by Using PuTTY

Logging In to the Server Node over a Serial Port by Using PuTTY


  1. Double-click PuTTY.exe.

    The PuTTY Configuration window is displayed.

  2. In the navigation tree, choose Connection > Serial.
  3. Set the login parameters.


    • Serial line to connect to: COMn
    • Speed (baud): 115200
    • Data bits: 8
    • Stop bits: 1
    • Parity: None
    • Flow control: None

    n indicates the serial port number, and the value is an integer.

  4. In the navigation tree, choose Session.
  5. Set Connection type to Serial and set Close window on exit to Only on clean exit. See Figure 10-17.


    Configure Host Name (or IP address) and Saved Sessions, and click Save. You can double-click the saved record in Saved Sessions to log in to the server next time.

    Figure 10-17 PuTTY Configuration window

  6. Click Open.

    The PuTTY window is displayed.


    If you are logging in to the target server for the first time, the PuTTY Security Alert window is displayed. If you trust this site, click Yes. Then the PuTTY window is displayed.

  7. Enter a user name and password to log in.


    If the user name or password is incorrect during server login, you must connect to PuTTY again.

    After login, the server host name is displayed to the left of the prompt.

Updated: 2019-01-08

Document ID: EDOC1100033003

Views: 9551

Downloads: 12

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next