No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 9800 V100 Configuration Guide 03

This document introduces service configuration process for OSN 9800.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Precautions for Service Configuration

Precautions for Service Configuration

Misoperations during service configuration may make services unavailable. This topic describes the precautions that must be taken during service configuration.

Constraints on Cross-Connection Configuration

Cross-connections of WDM equipment are classified into optical and electrical cross-connections. Optical cross-connections groom optical signals and are irrelevant to the types of carried services. Electrical cross-connections groom electrical signals and are closely related to the types of carried services.

Pay attention to the following points when configuring electrical cross-connections:

  • For a common cross-connect service on a tributary board, its source can function as the source of another cross-connect service but its sink cannot be the sink of another cross-connect service. For an SNCP cross-connect service on a tributary board, neither of the two sources or sinks on the working and protection channels can function as the sources or sinks of other cross-connect services.
  • The transmit end and receive end in the same direction of a cross-connect service must have the same WDM-side channel ID.

    For example, when ODU Timeslot Configuration Mode of an N216 board is set to Assign consecutive, the mapping path of the ODU0 signal received on the backplane side is ODU0 -> ODU1 -> ODU2, and the channel of each optical port on the board is OCh:1-ODU2:1-ODU1:(1-4)-ODU0:(1-2). If the optical port and channel of the N216 board at the transmit end are 1(IN1/OUT1)-OCh:1-ODU2:1-ODU1:1-ODU0:1, the channel used by the N216 board at the receive end must be OCh:1-ODU2:1-ODU1:1-ODU0:1 of any optical port among the 16 available optical ports of the N216 board at the receive end.

Translation
Download
Updated: 2019-09-05

Document ID: EDOC1100033663

Views: 21052

Downloads: 706

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next