No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 9800 V100 Configuration Guide 03

This document introduces service configuration process for OSN 9800.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
E2E Service Configuration Procedure

E2E Service Configuration Procedure

E-Line services carried on PWs, namely, virtual private wire service (VPWS) services, are also known as PWE3 services in E2E service configuration. A 9800 packet network supports E2E configuration of PWE3 services. This topic describes the E2E configuration process of PWE3 services.

NOTE:

Before configuring an Ethernet service on a packet network in E2E mode, ensure that the optical layer of the packet network has been commissioned and configured, and the desired NEs, logical boards, and logical fibers have been created.

If a universal line board is used to receive and transmit packet services, configure ETH virtual ports of the universal line board and ODUk mapping paths on the U2000 before configuring services following the configuration procedure. For details, see Configuring Virtual Ports for Universal Line Boards.

In this configuration mode, the user can configure tunnel automatic protection switching (APS) and PW APS during the configuration of a multiprotocol label switching (MPLS) tunnel and a PWE3 service. For an Ethernet service with tunnel APS or PW APS and an Ethernet service without tunnel APS or PW APS, the configuration procedures are the same but the parameters that need to be set vary. For details, see Configuring an MPLS Tunnel and Configuring a PWE3 Service.

This topic describes the procedure for configuring an Ethernet service without tunnel APS or PW APS on a packet network in E2E mode, as shown in Figure 3-11.

Figure 3-11 Configuration procedure
Translation
Download
Updated: 2019-09-05

Document ID: EDOC1100033663

Views: 19414

Downloads: 682

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next