Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Process of CES Services
This topic describes the configuration process of UNI-UNI and UNI-NNI CES services.
Configuration Process for UNI-NNI CES Services
This topic describes the operation tasks for configuring UNI-NNI CES services and the relationships between the operations tasks.
Figure 4-1 provides the process for configuring UNI-NNI CES services.
Table 4-1 Tasks for configuring UNI-NNI CES services
| Task | Remarks | |
|---|---|---|
| 1 | 1. Creating a Network | Create NEs, configure NE data, and create fibers connections. |
| 2 | Configuring the LSR ID | Set the NE LSR ID. |
| 3 | Configuring the Network-Side Interface | Set the basic attributes and Layer 3 attributes for interfaces to carry the tunnel carrying. |
| 4 | Configuring the MPLS Tunnel | Set MPLS tunnel parameters based on service planning. |
| 5 | Configuring the CES Service Interface | Use the channelized STM-1/stm-4 board to transmit services on the user side. |
| 6 | Set VC12/VC4 channel overheads | Configuring regenerator section overhead, VC-4 channel overhead, and VC-12 channel overhead. |
| 7 | Configuring the UNI-NNI CES service | Configuring CES services. |
Previous
