No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 9800 V100 Configuration Guide 03

This document introduces service configuration process for OSN 9800.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Composite Service (Method 1, Recommended)

Configuring a Composite Service (Method 1, Recommended)

A composite service can be configured using two methods. This topic describes how to configure a composite service using method 1, which is preferred due to its simplicity.

Configuring a Composite Service Without PW APS

This topic describes how to configure a composite service without PW automatic protection switching (APS).

Prerequisites

Procedure

  1. From the main menu of the U2000, choose Sevice > Composite Sevice > Create Composite Sevice. The Create Composite Service window is displayed.

  2. On the General tab, set Creation Type to H-VPLS.

  3. Click Add VPLS Node-SAI. In the Select VPLS Node window that is displayed, click the Add Device tab. On the tab, select the NE where a virtual private LAN service (VPLS) service needs to be configured, and select the required board, port, and service VLAN. Click OK.

  4. Click Add PWE3 Node. In the Select PWE3 Node window that is displayed, select the NE where a pseudo wire emulation edge-to-edge (PWE3) service needs to be configured, select the required board, port, and service VLAN, and click OK.

  5. Click the PW Configuration tab in the lower right corner and select the tunnel that forwards the desired PW.

  6. Click OK or Apply to complete the configuration of the composite service.

  7. In the Operation Result dialog box, click Browse Trail to view the newly created composite service.

  8. Right-click the composite service and choose Ethernet OAM > Start CC from the shortcut menu.
  9. In the Start CC window that is displayed, select an MA from MA Information List and click . The selected MA is displayed in Selected MA Information List. Click OK.
  10. Right-click ETH OAM Configuration View and choose LB Test.
  11. In the LB Test window that is displayed, select the composite service and click Run to start a loopback (LB) test.

Configuring a Composite Service with PW APS

The procedures for configuring a composite service with PW automatic protection switching (APS) is similar to that for configuring a composite service without PW APS are. The difference is that PW APS parameters must be set for the former. This topic only describes the operations that are not required for configuring a composite service without PW APS.

Prerequisites

Configuration Networking Diagram



Procedure

  1. On the PW Configuration tab, select the tunnels of the working and protection PWs.

  2. On the PWE3 Protection Parameter tab, set Protection Mode, Enable Status, and Switching Mode.

    NOTE:

    If Protection Mode has been set to 1:1, Switching Mode must be set to Dual-ended Switching.

  3. The other operations are the same as those for creating a composite service without PW APS. For details, see 1.
Translation
Download
Updated: 2019-09-05

Document ID: EDOC1100033663

Views: 21320

Downloads: 711

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next