No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 9800 V100 Configuration Guide 03

This document introduces service configuration process for OSN 9800.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Example: E-Line Services Carried by PWs

Configuration Example: E-Line Services Carried by PWs

This section uses an example to describe how to configure E-Line services carried by PWs based on the service plan.

Networking Diagram

The networking diagram shows the requirements for VLAN-based E-Line services carried by PWs.

On the network shown in Figure 3-29, the service requirements of User A and User B are as follows:

  • Users A1 and B1 are connected to NE1 through the E124-1 and E124-2 ports respectively.
  • Users A2 and B2 are connected to NE3 through the E124-1 and E124-2 ports respectively.
  • The service between users A1 and A2 is a common Internet access service.
  • The service between users B1 and B2 is a data service.
  • The services of users A and B each are carried on one PW.
  • The two PWs that carry the services of users A and B share the bandwidth of one tunnel.
Figure 3-29 Networking diagram of VLAN-based E-Line services carried by PWs

NOTE:

On an existing data network, an Ethernet service is added to the source NE, passes through intermediate NEs, and is dropped from the sink NE. Follow instructions in Configuring Transit NEs for Ethernet Services Carried by PWs to configure intermediate NEs for the Ethernet services carried by PWs.

NE IP Address IP Mask LSR ID
NE1 Vp0/32/0/40001 10.1.1.1 255.255.255.252 172.16.0.1
NE2 Vp0/32/0/40001 10.1.1.2 255.255.255.252 172.16.0.2
Vp0/32/0/40002 10.1.1.5 255.255.255.252
NE3 Vp0/32/0/40001 10.1.1.6 255.255.255.252 172.16.0.3
NOTE:
  • The IP addresses of the Ethernet ports on an NE cannot be in the same network segment.
  • The IP addresses of the ports at both ends of a tunnel cannot be in the same network segment.

Service Planning

The engineering information for configuring E-Line services carried by PWs contains the engineering information for configuring the tunnel carrying the PWs, for configuring the PWs, and for configuring the UNI-NNI E-Line services carried by the PWs.

The PWs carrying E-Line services are carried by a tunnel. Therefore, you need to plan the tunnel during service planning. Therefore, planning the E-Line services carried by PWs involves the following:
  • Plan the tunnel that carries the PWs. Refer to Table 3-26.
  • Plan the UNI-NNI E-Line services carried by PWs, and PWs. Refer to Table 3-27.
Table 3-26 Tunnel planning
Tunnel Description NE Tunnel ID TunnelName LSR Role InBearerType OutBearerType Inbound Interface Name Incoming Label Incoming Label Outbound Interface Name Outgoing Label Outgoing Label Forward NextHop Reverse NextHop Ingress LSR ID Sink LSR ID
NE1_NE3 NE1 10 Tunnel0/48/16843014/3366441096 Ingress Interface Interface - - 103 Vp0/32/0/40001 100 - 10.1.1.2 - - 172.16.0.3
NE2 Transit Interface Interface Vp0/32/0/40001 100 102 Vp0/32/0/40002 101 103 10.1.1.6 10.1.1.1 172.16.0.1 172.16.0.3
NE3 Egress Interface Interface Vp0/32/0/40001 101 - - - 102 - 10.1.1.5 172.16.0.1 -
Table 3-27 Planning for PWs and the UNI-NNI E-Line services carried by PWs

Parameter

User A

User B

Service ID

1

2

Service Name

E-Line-1

E-Line-2

Service Type

UNI-NNI

UNI-NNI

PW Type

Ethernet

Ethernet

MTU(bytes)

1500

1500

Service Tag Role

User

User

L2VPN AC List-L2VPN AC-Port

GigabitEthernet0/16/0/1

GigabitEthernet0/16/0/2

PW Role

Working

Working

PW ID

35

45

PW Signaling Type

Static

Static

Peer LSR ID

NE1

172.16.0.3

172.16.0.3

NE3

172.16.0.1

172.16.0.1

PW Direction

Bidirectional

Bidirectional

PW Incoming Label

20

30

PW Outgoing Label

20

30

Control Word

Use preferred

Use preferred

Tunnel

Tunnel0/48/16843014/3366441096

Tunnel0/48/16843014/3366441096

Tunnel Type

MPLS

MPLS

PW Status

Enabled

Enabled

Configuring E-Line Services on a Per-NE Basis

This topic describes how to configure E-Line services carried by PWs on a per-NE basis, based on the service planning.

Prerequisites

  • You must be an NM user with "NE operator" authority or higher.
  • You must understand the networking, requirements and service planning of the example.

Tools, Equipment, and Materials

NMS

Procedure

  1. Configure Ethernet port attributes. Basic attributes and Layer 2 attributes need to be configured for the UNI ports based on the service planning. For details, see Configuring an Ethernet Port.
  2. Configure the NNI ports for the Ethernet services carried by static MPLS tunnels. For details, see Configuring the NNIs for Ethernet Services Carried by Static MPLS Tunnels.

    NE IP Address Specify Mode IP Address IP Subnet Mask
    NE1 Vp0/32/0/40001 Manually 10.1.1.1 255.255.255.252
    NE2 Vp0/32/0/40001 Manually 10.1.1.2 255.255.255.252
    Vp0/32/0/40002 Manually 10.1.1.5 255.255.255.252
    NE3 Vp0/32/0/40001 Manually 10.1.1.6 255.255.255.252

  3. Optional: Create Ethernet virtual interfaces. Configure the Ethernet virtual interfaces based on the service planning. For details, see Configuring Ethernet Virtual Interfaces.

    NOTE:

    Ethernet virtual interfaces can be configured on UNI or NNI ports based on the network plan. When VLAN sub-interfaces or stacking sub-interfaces are configured, you can configure the interfaces on AC ports during creation of E-Line services; when VLAN aggregation sub-interfaces are configured, you can configure the interfaces as the ingress or egress interfaces during creation of tunnels.

  4. Configure the working tunnels for carrying PWs on NE1, NE2, and NE3. For details about how to configure the tunnels, see Configuring an MPLS Tunnel.

    Table 3-28 Tunnel planning
    Tunnel Description NE Tunnel ID TunnelName LSR Role InBearerType OutBearerType Inbound Interface Name Incoming Label Incoming Label Outbound Interface Name Outgoing Label Outgoing Label Forward NextHop Reverse NextHop Ingress LSR ID Sink LSR ID
    NE1_NE3 NE1 10 Tunnel0/48/16843014/3366441096 Ingress Interface Interface - - 103 Vp0/32/0/40001 100 - 10.1.1.2 - - 172.16.0.3
    NE2 Transit Interface Interface Vp0/32/0/40001 100 102 Vp0/32/0/40002 101 103 10.1.1.6 10.1.1.1 172.16.0.1 172.16.0.3
    NE3 Egress Interface Interface Vp0/32/0/40001 101 - - - 102 - 10.1.1.5 172.16.0.1 -

  5. Configure E-Line services for users A1, B1, A2, and B2 on NE1 and NE3. For details about how to configure the services, see Configuring UNI-NNI E-Line Services Carried by PWs.

    Table 3-29 Planning for PWs and the UNI-NNI E-Line services carried by PWs

    Parameter

    User A

    User B

    Service ID

    1

    2

    Service Name

    E-Line-1

    E-Line-2

    Service Type

    UNI-NNI

    UNI-NNI

    PW Type

    Ethernet

    Ethernet

    MTU(bytes)

    1500

    1500

    Service Tag Role

    User

    User

    L2VPN AC List-L2VPN AC-Port

    GigabitEthernet0/16/0/1

    GigabitEthernet0/16/0/2

    PW Role

    Working

    Working

    PW ID

    35

    45

    PW Signaling Type

    Static

    Static

    Peer LSR ID

    NE1

    172.16.0.3

    172.16.0.3

    NE3

    172.16.0.1

    172.16.0.1

    PW Direction

    Bidirectional

    Bidirectional

    PW Incoming Label

    20

    30

    PW Outgoing Label

    20

    30

    Control Word

    Use preferred

    Use preferred

    Tunnel

    Tunnel0/48/16843014/3366441096

    Tunnel0/48/16843014/3366441096

    Tunnel Type

    MPLS

    MPLS

    PW Status

    Enabled

    Enabled

Translation
Download
Updated: 2019-09-05

Document ID: EDOC1100033663

Views: 19113

Downloads: 669

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next