No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Client-Initiated L2TP Connection

Client-Initiated L2TP Connection

Traveling employees need to communicate with employees in the headquarters and access the headquarters gateway through the Internet to use internal resources. However, the headquarters gateway cannot identify and manage access users. To solve this problem, configure the headquarters gateway as the LNS to establish a virtual point-to-point connection between the traveling employees and the headquarters gateway when the employees use the L2TP dial-up software on the PC to initiate L2TP connections. The LNS can authenticate access users and assign private network addresses. The LNS can use ACLs to manage users' access rights.

Figure 1-7  Client-initiated L2TP connection
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 144530

Downloads: 361

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next