No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of IPSec Tunnel Establishment

Verifying the Configuration of IPSec Tunnel Establishment

Prerequisites

The configurations of the ACL-based IPSec tunnel are complete.

Procedure

  • Run the display ipsec proposal [ brief | name proposal-name ] or display ipsec proposal [ brief | name proposal-name ] ctrl-plane command to check IPSec proposal information.
  • Run the display ipsec policy [ brief | name policy-name [seq-number ] ] or display ipsec policy [ brief | name policy-name [ seq-number ] ] ctrl-plane command to check IPSec policy information.
  • Run the display ike identity [ name identity-name ] command to check identity filter set information.
  • Run the display ipsec policy-template [ brief | name policy-template-name [ seq-number ] ] or display ipsec policy-template [ brief | name policy-template-name [ seq-number ] ] ctrl-plane command to check IPSec policy template information.
  • Run the display ipsec sa [ brief | duration | policy policy-name [ seq-number ] | remote ipv4-address ] command to check IPSec SA information.
  • Run the display ipsec global config command to check global IPSec configuration.
  • If an IPSec tunnel is established in IKE negotiation mode, check the IKE configuration. See Verifying the IKE Configuration.
Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 143599

Downloads: 361

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next