No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Collecting Statistics About L3VPN Traffic

Collecting Statistics About L3VPN Traffic


L3VPN traffic statistics collection is applicable to the interface traffic at the user side of a VPN. Before collecting L3VPN traffic statistics, you need to enable the L3VPN traffic statistics function.

  • Currently, L3VPN traffic statistics collection can count only unicast packets.
  • In L3VPN over MPLS TE scenarios, if the device is enabled to collect L3VPN traffic statistics and traffic statistics on an MPLS TE tunnel interface simultaneously, packets received from the interface bound to a VPN instance are not counted as L3VPN traffic.
  • Enabling L3VPN traffic statistics function may affect the forwarding performance. For example, when all interfaces provide line-speed forwarding, some interface may be unable to forward packets at line speed. Exercise caution when you enable traffic statistics on a VLANIF interface.
  • L3VPN traffic statistics is unavailable for error packets.

Perform the following steps on the device:


  1. Run the system-view command to enter the system view.
  2. Run the ip vpn-instance vpn-instance-name command to enter the VPN instance view.
  3. Run the traffic-statistics enable command to enable the function of collecting statistics about L3VPN traffic.
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 154114

Downloads: 372

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next