No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Enabling Dependency Between IPSec SA and IKE SA During IKEv1 Negotiation

(Optional) Enabling Dependency Between IPSec SA and IKE SA During IKEv1 Negotiation

Context

By default, no dependency exists between IPSec SA and IKE SA, that is, the two SAs can be deleted separately. If the IKE SA is deleted but the corresponding IPSec SA still exists, traffic forwarding will be effected. You can enable dependency between IPSec SA and IKE SA to ensure that an IPSec SA is deleted when its corresponding IKE SA is deleted.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ikev1 phase1-phase2 sa dependent

    Dependency between IPSec SA and IKE SA during IKEv1 negotiation is enabled.

    By default, no dependency exists between IPSec SA and IKE SA during IKEv1 negotiation.

Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 152437

Downloads: 369

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next