No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Martini VPLS

Configuring Martini VPLS

This section describes how to configure VPLS in Martini mode using LDP as the signalling protocol.

Pre-configuration Task

Before configuring Martini VPLS, complete the following tasks:
  • Configuring the LSR ID on the PEs and Ps and enabling MPLS and MPLS LDP

  • Establishing tunnels between PEs for transmitting data
  • Setting up an LDP session if PEs are indirectly connected

Configuration Procedure

To configure Martini VPLS, perform the following configurations on PEs at both ends of a PW.

Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 145291

Downloads: 361

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next