No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Alarm Report Function

Configuring the Alarm Report Function

Context

You can configure the alarm report function, which help you obtain real-time running status of the VLL network and facilitate operation and maintenance.

Procedure

  • Configure alarm report for the CCC VLL.
    1. Run system-view

      The system view is displayed.

    2. Run snmp-agent trap enable feature-name l2vpn trap-name { hwcccvcdown | hwcccvcup }

      Alarm report for the CCC VLL is enabled.

      By default, alarm report for the CCC VLL is disabled.

  • Configure alarm report for the Martini VLL.
    1. Run system-view

      The system view is displayed.

    2. Run snmp-agent trap enable feature-name l2vpn trap-name { hwpwvcbackup | hwpwvcdeleted | hwpwvcdown | hwpwvcstatuschange | hwpwvcswitchptow | hwpwvcswitchwtop | hwpwvcup }

      Alarm report for the Martini VLL is enabled.

      By default, alarm report for the Martini VLL is disabled.

  • Configure alarm report for the SVC VLL.
    1. Run system-view

      The system view is displayed.

    2. Run snmp-agent trap enable feature-name l2vpn trap-name { hwsvcdeleted | hwsvcdown | hwsvcswitchptow | hwsvcswitchwtop | hwsvcup }

      Alarm report for the SVC VLL is enabled.

      By default, alarm report for the SVC VLL is disabled.

Verifying the Configuration

After completing the alarm report for VLL, you can run the following command to check whether alarm report is enabled.

  • Run the display snmp-agent trap feature-name l2vpn all command to check whether alarm report is enabled for the L2VPN module.

Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 145394

Downloads: 361

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next