No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Spoke Fails to Register with a Hub

Spoke Fails to Register with a Hub

Fault Description

After the display nhrp peer command is executed on the Hub, no NHRP mapping entry that records the mapping between the tunnel address of the Spoke and the public network address is displayed.


  1. Check that the Spoke has reachable routes to the remote Spoke and the Hub.

    Run the display ip routing-table command to check whether there are routes to the remote end.

    • If there is no reachable route between the Spoke and Hub, check the configurations of routes on the Spoke and Hub. For the configurations of routes, see the Huawei AR Series V200R010 Configuration Guide - IP Routing.
    • If there are reachable routes between the Spoke and Hub, go to step 2.

  2. Check that configurations of the Spoke and Hub are correct.

    Run the display nhrp peer command on the Spoke and Hub to check NHRP mapping entries.

    If the Hub does not have dynamic NHRP mapping entries of the Spoke, run the display this command on mGRE tunnel interfaces of the Spoke and Hub to check whether the configurations on both ends are consistent. The following table lists the fields in the command output that you need to check the follow-up operations.


    Check Standard and Operation

    nhrp authentication

    Check whether NHRP authentication string configurations of the Spoke and Hub are the same. If they are different, run the nhrp authentication command to modify the configurations.

    nhrp entry

    Check whether the static NHRP mapping entries on the Spoke contain the interface information of the Hub. If not, run the nhrp entry command to modify the configurations.

Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 143479

Downloads: 361

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next