No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - VPN

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R010

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the Running Status of L2TP

Monitoring the Running Status of L2TP


In routine maintenance, you can run the following commands in any view to view the running status of L2TP.


  • Run the display l2tp-group command to view the L2TP group number existing on the device.
  • Run the display l2tp tunnel [ tunnel-item tunnel-item | tunnel-name tunnel-name ] command to view the detailed connection parameters of a specified tunnel based on the local tunnel ID or the remote tunnel name.
  • Run the display l2tp session [ destination-ip d-ip-address | session-item session-item | source-ip s-ip-address ] command to view the detailed connection parameters of a specified session based on the local session ID and to view a session ID corresponding to a source or destination public network address of the L2TP tunnel.
Updated: 2019-08-07

Document ID: EDOC1100033725

Views: 142639

Downloads: 359

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next